Part III of the Making Of series. How we made the Sun and Planets in Blown Glass. Veerrrrrry carefully.
Enjoy The Full Story...
Casting glass seems a daunting process when you first consider learning it. It takes special equipment and a budget. It also takes patience and perseverance to succeed. A bit of courage doesn't hurt either but wonderful things are possible.
Enjoy The Full Story...
I made my own gear yesterday!! I'm so proud of it I could just burst.
A little background - I'm building on orrery (model of the solar system) for the astronomy department of a college in San Mateo, CA. We've built similar things, but of course, every new project requires new skills and stuff that we've never done before. For this piece, called
Enjoy The Full Story...
While we were at the National Space Symposium, a next door exhibitor asked if we could put together some small awards for students. The catch was he didn't have much time. I came back to the studio and looked around for something that I had already in stock that would do well as awards, but I only had two or three of each appropriate thingie, and he needed 5
Enjoy The Full Story...
I wanted to experiment with my sandblasting and deep carving on glass. My cast glass pieces are usually in the 3/8-1/2 inch thick range, with the colors swirling through the entire depth of the piece. This would make for some great carving, as some of the colors would be opened up, while others would remain untouched.
Since I was getting ready for a space conference, I decided to
Enjoy The Full Story...
Previous posts have focused on the rocket that is the center column for our orrery. The one pictured here doesn't have the bottom section with the fins, but our new one does. Now that the rocket has been carved and the holes bored into it to accept the drive tubes, it can be put aside for a bit and we move on to the next section - The
Enjoy The Full Story...